With the inclinometer CM 09606, the vehicle level (ride height) is gauged using the position of the transverse link on the front axle and the drive shaft on the rear axle as reference points. The results of which are displayed in both decimal degrees and millimeters which are then used to determine the adjustment values for wheel camber, caster and toe. The whole process takes just one minute.
Structure and function
The inclinometer CM 09606 consists of the handheld unit with graphics module and sensor for measuring two levels. The measuring range is +/- 15°.
To measure the lower transverse link of the front axle, the provided magnetic adaption plate 09606-50 is set in the designated recess to provide support for the sensor.
Place the sensor with the points onto the adaption plate. The gauge results are shown on the display and saved by pressing the "Save" key. For gauging both the left and right side of the vehicle, ensure the spiral cord points toward the middle of the vehicle.
No adapter is needed for measuring the rear axle shaft. The sensor points can be held directly onto the drive shaft (exception M Class W163; see accessories). Once again the spiral cord should point toward the center of the vehicle. After saving all four measurements, the data can be transmitted to the wheel alignment computer either via interface (serial or USB) or by using the accessory unit "Data transfer and charging station 09630-10". The precise settings will be assigned automatically.
Characteristics
- high gauge accuracy
- easiest handling
- power supplied by customary rechargeable batteries (4 x Mignon
AA 1.2V/2100 mAh)
- battery charger
Technical data
- CE certificate, Protection IP65
- Power supply: 4.8V – 6V, 0.8W
- Angle measuring range: +/- 15°, accuracy +/- 0.1°
- Equipment: USB-Interface and serial R232 for data Transfer, battery charger
(12 V / 250 mA)
- Measurements (in mm): L x W x H: 450 x 380 x 120 (with case) approx.
130 x 280 x 70 (without case)
- Packing measurements (in mm): L x W x H: 455 x 400 x 120
Scope of delivery
Operating device with display, inclinometer, power supply, standard adapter (09606-50), carrying case.
Accessories
- data transfer and charging station with power supply, data cord
(9 pole, 1.2 m length) (09630-10)
- interaxle-adapter (Type W163 M-class), MV-level measuring front axle
(09606-60)
- interaxle-adapter (Type W163 M-class), wheel caster measurement rear axle
(09606-61)
- adapter for W 414 (Vaneo) station wagon and panel truck (09606-62).
Order Numbers
09606-10 (230 V / 50 Hz)
09606-11 (110 V / 60 Hz)
Modifications and errors reserved.